Sensores

Código

Código para teste do sensor MAX-31856 usando a placa NodeMCU 1.0 com chip esp8266-12E

#include <Adafruit_MAX31856.h>

// Use software SPI: CS, DI, DO, CLK
//Adafruit_MAX31856 maxthermo = Adafruit_MAX31856(10, 11, 12, 13);
//Adafruit_MAX31856 maxthermo = Adafruit_MAX31856(15, 13, 12,14);

// use hardware SPI, just pass in the CS pin
// NODEMCU 1.0 ESP8266-12E
//    CS - GPIO 15 - D8
//    DI - GPIO 13 - D7
//    DO - GPIO 12 - D6
//    CLK- GPIO 14 - D5

Adafruit_MAX31856 maxthermo = Adafruit_MAX31856(15);

void setup() {
  Serial.begin(115200);
  Serial.println("MAX31856 thermocouple test");

  maxthermo.begin();

  maxthermo.setThermocoupleType(MAX31856_TCTYPE_K);


  Serial.print("Thermocouple type: ");
  switch (maxthermo.getThermocoupleType() ) {
    case MAX31856_TCTYPE_B: Serial.println("B Type"); break;
    case MAX31856_TCTYPE_E: Serial.println("E Type"); break;
    case MAX31856_TCTYPE_J: Serial.println("J Type"); break;
    case MAX31856_TCTYPE_K: Serial.println("K Type"); break;
    case MAX31856_TCTYPE_N: Serial.println("N Type"); break;
    case MAX31856_TCTYPE_R: Serial.println("R Type"); break;
    case MAX31856_TCTYPE_S: Serial.println("S Type"); break;
    case MAX31856_TCTYPE_T: Serial.println("T Type"); break;
    case MAX31856_VMODE_G8: Serial.println("Voltage x8 Gain mode"); break;
    case MAX31856_VMODE_G32: Serial.println("Voltage x8 Gain mode"); break;
    default: Serial.println("Unknown"); break;
  }


}

void loop() {
  Serial.print("Cold Junction Temp: "); 
  Serial.println(maxthermo.readCJTemperature());

  Serial.print("Thermocouple Temp: ");
  Serial.print("oPS... "); 
  Serial.println(maxthermo.readThermocoupleTemperature());
  // Check and print any faults
  uint8_t fault = maxthermo.readFault();
  if (fault) {
    if (fault & MAX31856_FAULT_CJRANGE) Serial.println("Cold Junction Range Fault");
    if (fault & MAX31856_FAULT_TCRANGE) Serial.println("Thermocouple Range Fault");
    if (fault & MAX31856_FAULT_CJHIGH)  Serial.println("Cold Junction High Fault");
    if (fault & MAX31856_FAULT_CJLOW)   Serial.println("Cold Junction Low Fault");
    if (fault & MAX31856_FAULT_TCHIGH)  Serial.println("Thermocouple High Fault");
    if (fault & MAX31856_FAULT_TCLOW)   Serial.println("Thermocouple Low Fault");
    if (fault & MAX31856_FAULT_OVUV)    Serial.println("Over/Under Voltage Fault");
    if (fault & MAX31856_FAULT_OPEN)    Serial.println("Thermocouple Open Fault");
  }
  delay(1000);
}