Mudanças entre as edições de "Servidor Desenvolvimento:Configuracao BIOS:Boot Sequence"

De MediaWiki do Campus São José
Ir para navegação Ir para pesquisar
 
(Uma revisão intermediária pelo mesmo usuário não está sendo mostrada)
Linha 1: Linha 1:
 
<code>
 
<code>
[ ] Onboard or USB Floppy Drive                  [   WDC WDC2500AAJS-75M0A0 ]
+
[ ] Onboard or USB Floppy Drive                  [ATA0-WDC WDC2500AAJS-75M0A0]
[v] WDC WD2500AAJS-75M0A0                         [Onboard or USB CD-ROM Drive]
+
[v] SATA0-WDC WD2500AAJS-75M0A0                   [Onboard or USB CD-ROM Drive]
 
[v] Onboard or USB CD-ROM Drive                   
 
[v] Onboard or USB CD-ROM Drive                   
 
[ ] Onboard Network Controller
 
[ ] Onboard Network Controller
Linha 13: Linha 13:
 
or not applicable in the current SATA mode. Also note that reloading defaults can be used to
 
or not applicable in the current SATA mode. Also note that reloading defaults can be used to
 
remove these dormant boot entries.
 
remove these dormant boot entries.
 +
                                                           
 +
                                    [ Load Defaults ]  [    Apply    ]  [      Exit    ]
 
</syntaxhighlight>
 
</syntaxhighlight>

Edição atual tal como às 16h15min de 26 de novembro de 2010

[ ] Onboard or USB Floppy Drive [ATA0-WDC WDC2500AAJS-75M0A0] [v] SATA0-WDC WD2500AAJS-75M0A0 [Onboard or USB CD-ROM Drive] [v] Onboard or USB CD-ROM Drive [ ] Onboard Network Controller

This list specifies the order that the BIOS searches devices when trying to find an operanting system to boot. To change the boot select the device to be changed in the list on the rigth hand side, then click UP/DN arrows, or press the PgUp/PgDn keys of SHIFT-UP/DN arrow keys to change the boot order of the device. The boot devices can also be selected or de-selected from list using the check boxes on the left hand side. The F7 hotkey will toggle displaying of dormant boot entries. These are entries for devices that are not present or not applicable in the current SATA mode. Also note that reloading defaults can be used to remove these dormant boot entries.

                                    [ Load Defaults ]   [     Apply     ]   [      Exit     ]

</syntaxhighlight>